Burcam 400409T SEWAGE PUMP 2HP 230V - Manual (Page 2)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is designed from the latest in material and
workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO
ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE
BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY
WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME
ELECTRICAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A
FUSE OR A CIRCUIT BREAKER. WE ALSO RECOMMEND THAT A GROUND
FAULT CIRCUIT BE USED. CONSULT A LICENSED ELECTRICIAN FOR ALL
WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER
BE REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR YOUR PRO-
TECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. DO NOT ONLY UNSCREW
THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER PLUG FROM
THE RECEPTACLE.
A
B
C
D
Material required for sewage pump application
Desired length of ABS/DWV 2” pipe, to link up from pump discharge to waste or drain
existing pipe.
Required quantities of 2” ABS/DWV elbow(s) and/or other fitting(s) to run the
discharge line.
1 only 2” ABS/DWV male adaptor to 2” slip, to connect the discharge pipe to the pump.
Desired length of ABS/DWV 3” pipe and required quantities of 3” ABS/DWV elbow(s).
and/or other fitting(s) to run the vent line.
1 only 2” union check valve # 450457.
1 only 18” X 30” minimum size sewage basin like # 400420.
Teflon tape and ABS cement.
2
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe
ends, pipe wrench, adjustable wrench, 1/4” drill bit and drill.
Ensure that you have a gas tight cover for your sewage basin and 3” ABS/DWV vent
piping.
NOTICE
This unit is not designed for applications
involving salt water or brine .
Use with salt water or brine will void
warranty.