Burcam 300209DP DIAPHRAGM UTILITY PUMP 12V/115V 1/12HP - Manual (Page 2)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
APPLICATION
☐ Designed for water transfer to empty waterbeds,
aquariums, or to remove water from roof tops, puddles, etc.
☐ This utility pump can be powered with
a car battery or solar panels.
☐ CAPACITY:
5’ 350 GPH US
20’ 320 GPH US
40’ 250 GPH US
FEATURES
☐ Non corrosive material.
☐ 12Volt DC or 115 Volts AC.
FRICTION LOSS IN
PIPE NOT INCLUDED.
SAFETY INSTRUCTIONS :
This fine pump that you have just purchased is designed from the latest in material and workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO ENSURE YOU COMPLY
WITH THE REGULATIONS. THESE CODES HAVE BEEN DESIGNED WITH YOUR SAFETY IN
MIND. BE SURE YOU COMPLY WITH THEM.
DO NOT SUBMERGE MOTOR OR ALLOW MOTOR TO BE EXPOSED TO WATER. PERSONAL
INJURY AND/OR DEATH COULD RESULT.
THIS PUMP MODEL BECOMES VERY HOT DURING OPERATION.
DO NOT PUMP GASOLINE OR OTHER EXPLOSIVE LIQUIDS. DO NOT OPERATE PUMP WHERE
FLAMMABLE OR EXPLOSIVE FUMES OR GASES ARE PRESENT AS A FIRE OR EXPLOSION
COULD RESULT.
A
B
C
D
NOTICE
This unit is not designed for applications involving salt
water or brine. Use with salt water or brine will void
warranty.
IMPORTANT INFORMATIONS
☐ The automatic thermal overload protection shuts the motor off when it overheats. Normally, motor cools and restarts
automatically.
☐ If this pump is used for pumping abrasive liquids such as lake water, keep inlet above mud and sand. Any abrasive
liquids will damage the pump and void warranty.
☐ This pump will handle most common waterlike liquids at temperatures of 35°F to 100°F (1°C to 38°C). Thick liquids, fuels
(gasoline etc) or other flammable liquids, solvents, thinners and strong acids are totally prohibited and will void warranty.
PRIOR TO ANY USE CHECK-UP :
1. Inspect the pump for any obvious condition that necessitates cleaning, correction, adjustement or repair.
2. Clear the water source and the surroundings of any paper, leaves or other debris that might clog the input openings.
Remove anything that might float into the suction area.
3. Assure that the pump is secure for proper operation.
4. Assure that there is adequate clearance from any combustible materials or structure. Stored materials must be kept away from the
pump. Shelves or cabinet structures must not be in close proximity over the pump.
5. Observe that the plumbing can distribute the pumped water safely to the discharge point.
2