Burcam 300509P SUBMERSIBLE UTILITY PUMP (POOL/FOUNTAIN) 1/2HP 115V - Manual (Page 2)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is designed from the latest in material and
workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO
ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE
BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY
WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME
ELECTRICAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A
FUSE OR A CIRCUIT BREAKER. WE ALSO RECOMMEND THAT A GROUND
FAULT CIRCUIT BE USED. CONSULT A LICENSED ELECTRICIAN FOR ALL
WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER
BE REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR YOUR PRO-
TECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. DO NOT ONLY UNSCREW
THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER PLUG FROM
THE RECEPTACLE.
A
B
C
D
2
APPLICATION
❏ This submersible utility pump is designed for
a permanent installation or as a portable
application,
❏ Recommended to empty pools and can be
used where volume and / or flow extensive,
❏ May be used for average flow fountain.
❏ CAPACITY:
5’ 4000 US GPH
10’ 3000 US GPH
15’ 2750 US GPH
20’ 2150 US GPH
25’ 1800 US GPH
FEATURES
❏ Non corrosive material.
❏ Stainless steel mechanical rotary seal.
❏ Thermal and overload protection.
❏ 1/2HP, 115VAC, 60Hz, 4A, 8A (when start).
FRICTION LOSS
IN
PIPE NOT
INCLUDED
NOTICE
This unit is not designed for applications
involving salt water or brine .
Use with salt water or brine will void
warranty.