Burcam 300512 1/3HP SUBM. WATERFALL PUMP CONTINUOUS DUTY 115V - Manual (Page 2)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is designed from the latest in material and
workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO
ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE
BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY
WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME
ELECTRICAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A
FUSE OR A CIRCUIT BREAKER. WE ALSO RECOMMEND THAT A GROUND
FAULT CIRCUIT BE USED. CONSULT A LICENSED ELECTRICIAN FOR ALL
WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER
BE REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR YOUR
PROTECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. DO NOT ONLY UNSCREW
THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER PLUG FROM
THE RECEPTACLE.
A
B
C
D
2
APPLICATION
R This submersible utility pump is designed for
a portable application, for dewatering around
homes.
R This pump is great for water transfer
from basin, pool cover, flodded floor, flat roof.
R May also be used for waterfall, fountain.
R CAPACITY:
5’ 2270 US GPH
10’ 2100 US GPH
15’ 1700 US GPH
20’ 975 US GPH
FEATURES
R Non corrosive material.
R Stainless steel mechanical rotary seal.
R Thermal and overload protection.
R 1/3HP, 115VAC, 60Hz, 3.4 A, (6.1 A when start).
FRICTION LOSS
IN
PIPE NOT
INCLUDED
NOTICE
This unit is not designed for applications
involving salt water or brine .
Use with salt water or brine will void
warranty.