Boltek RLO-10 Relay Interface For LD-350 User Manual
Page 2
©2012 BOLTEK CORP
RLO-10 LD-350 Install Instructions 20121002
Locate pin 1 of the relay connector. Pin 1 is
towards the center of the LD-350. The
female ribbon cable connector and the LD-
350 have 14 holes/pins (2x7). It is important
that pin 1 is inserted into the connector
holes closest to the ribbon cable's red stripe.
Plug the ribbon cable into the relay
connector as shown. The relay connector
pin 1 must plug into the ribbon cable
connector holes closest to the red stripe.
The other end of the ribbon cable
connector at the rear of the LD-350 should
be facing upwards as shown.
Replace the LD-350 top cover and secure
it by replacing the four cover screws.
Peel the paper backing from the double-
sided tape on the bottom of the RLO-10
relay unit. Stick the relay unit to the top
cover of the LD-350 as shown. Plug the
ribbon cable connector on the RLO-10 as
shown.