ReadyLIFT Ford F550 Super Duty 4WD, 2005-2013 - Radius Arm Kit - Manual (Page 5)

Final Checks & Adjustments
Post Installation Warnings: Once the vehicle is lowered to the ground, check all parts which have rubber or ure-
thane components to insure proper torque. Torque wheels to factory specs. Move vehicle backwards and forwards a
short distance to allow suspension components to adjust. Turn the front wheels completely left then right and verify
adequate tire, wheel, brake line, and ABS wire clearance. Test and inspect steering, brake and suspension components
for tightness and proper operation. Inspect brakes hoses and ABS lines for adequate slack at full extension. Failure to
perform the post inspection checks may result in vehicle component damage and/or personal injury or death to driver
and/or passengers. Test drive vehicle and re-check the torque of all fasteners and re-torque wheels on vehicle. Re-
adjust headlamps.
Vehicle Handling Warning: Vehicles with larger tires and wheels will handle differently than stock vehicles. Take
time to familiarize yourself with the handling of your vehicle
.
Wheel Alignment/Headlamp Adjustment:
It is necessary to have a proper and professional wheel alignment performed by a certified alignment
technician. Align the vehicle to factory specifications. It is recommended that your vehicle alignment be
checked after any off-road driving. In addition to your vehicle alignment, for your safety and others, it is
necessary to check and adjust your vehicle headlamps for proper aim and alignment
Vehicle Re-Torque and Safety Inspection:
Upon completion of all services and adjustments performed on your vehicle, and within 50 miles of driving, check to en-
sure all fasteners and hardware are properly torqued to specification as noted in the vehicles factory service manual or
the torque chart included.
www.ReadyLIFT.com
ReadyLIFT Off Road Suspension
7490 Commercial Way
Henderson, NV 89011
Phone: (702)410-2300
Fax: (702)410-2794
Toll Free: (800)549-4620
Email: [email protected]