ReadyLIFT Toyota Tundra, 2007-2014 - Mid-Travel Uniball Upper Control Arm Kit - Manual (Page 5)

Notes and Maintenance:
Check for misalignment spacer bind. If the uni-
ball cup tapered edges make contact with mis-
align spacers, limit straps MUST be installed.
DO NOT LUBE UNI-BALLS , keep clean and dry.
A light layer of WD-40 is acceptable in wet
weather conditions.
GM 1500, 07-up: Spacer provided to mount
ABS wiring bracket.
Toyota Tundra, 07-up: Machined washers
provided to use between inner bushings sleeves
and frame where OE bolt attaches.
Toyota Tacoma 6 lug, 05-up: Machined
washers provided to use between inner bush-
ings sleeves and frame where OE bolt attaches.
TOYOTA Tundra/Tacoma: Special atten-
tion is required when removing and installing
the UCA hardware on these model vehicles on
both pass/dr sides. It will help to remove the
rubber splash guards from the fender well and
frame. Take care to carefully remove the UCA
mounting bolts and move hoses and wiring to
prevent damage. It may be necessary to re-
move the battery and bend the inner body work
in order to remove mounting bolts. PLEASE
CALL for any additional help or questions.
www.ReadyLIFT.com
Phone (702)410-2300
Installation Instructions (OFF-Road Series 44-XXXX UCA kits)
Reattach ABS wiring removed previously onto UCA Reinstall wheels/tires and lower vehicle to ground
Example photo 2 (Dodge Ram 1500 UCA)
Photos shows inner fender splash guard, remove clips Photo shows UCA mounting bolt and battery proximity