Nematron iPC-Fanless Series with N2800 CPU User Manual
Page 12
________________________________________________________________________________________
Document No. DOC-IPC-003,
User Manual iPC-Series & nPC300, Rev B Rel. 12-2013
Page 12 of 24
Chapter 2 - Installation of Computer
Panel Mount iPC-Series Unit installation
The panel mount versions of the iPC-Series are intended to be mounted in and used where NEMA 1,
NEMA 4/4x and NEMA 12 type enclosures are employed. Enclosures made of heavier gauge metal work
better because they won’t deform or bend as easily when the monitor’s sealing gasket is compressed. The
monitor meets NEMA 4/12 sealing specifications when properly installed in an approved NEMA enclosure
constructed from 14-gauge or heavier steel. The computer
uses “U”-shaped clips and a special gasket to
achieve the proper seal.
When selecting an enclosure remember to allow adequate space around the rear of the computer for
good air flow. Do not block air flow from below or above the monitor. If possible mount the computer in a
vertical orientation. The unit is designed to work in environments up to 50 degrees Centigrade ambient
temperature inside the enclosure. Remember to account for heat dissipated from other equipment that may be
installed inside the same enclosure.
To install the computer, make a cutout according to the diagrams below in one of the walls of your
NEMA enclosure. Next hold the unit in place while you install the mounting clips. Tighten the clips to the
point were the back of the unit
’s front bezel just begins to contact the front of the NEMA enclosure. The use of
an adjustable torque driver is recommended. The screws should be tightened to 8 inch-pounds. Tighten the
clips in a cross pattern. This will help to develop an even pressure on the sealing gasket. DO NOT OVER
TIGHTEN AS DAMAGE CAN RESULT IN THE COMPUTER CAUSING LOSS OF SEALING INTEGRITY.
iPC1200
iPC1500
iPC1700
iPC1900
Cutout
Dimensions
(H x W)
9.68” x 12.10”
(245.9mm x
307.3mm)
12.00” x 15.00”
(305mm x
381mm)
13.70” x 16.35”
(348mm x
415.3mm)
14.90” x 17.75”
(378.5mm x
450.9mm)