Nexo 45N Monitor - Manual (Page 8)

Page 8/26 45N12 G ENERAL S ET - UP I NSTRUCTIONS
2 45N12 G
ENERAL
S
ET
-
UP
I
NSTRUCTIONS
2.1 Speaker connection
NEXO 45°N-12 are connected with Speakon NL4FC plugs (not supplied). A wiring diagram is printed on
the connection panel located on the back of each cabinet. The 4 pins of the 2 Speakon sockets
identified in / out are connected in parallel within the enclosure.
Either connector can be used to connect amplifier or to link to an additional 45N12 cabinet.
2.1.1 45°N-12 Connector Panel
Connectors are wired as follows:
2.1.2 Configuring 45N12 for Passive or Active Mode
IMPORTANT
45N12 are factory configured in active mode
In order to change active or passive configuration:
- remove the TORX screws that hold the rear/bottom metal panel;
- remove the rear/bottom metal panel to access passive network WAGO connectors.
In Passive Mode, WAGO connector should be inserted in “Passive In”, and speakers WAGO
connectors should be inserted in connector “Passive Out”.
In Active Mode, WAGO Connector should be directly connected to speakers via speakers WAGO
connectors (passive filter is then bypassed).
Speakon
Connector
Passive
Mode
Active
Mode
1(-) Ö Not Connected 45N12 LF (-)
1(+) Ö Not Connected 45N12 LF (+)
2(-) Ö 45N12 (-) 45N12 HF (-)
2(+) Ö 45N12 (+) 45N12 HF (+)