MAHLE RTI TC2670 - Manual (Page 15)

RTI Technologies, Inc.
September 30, 1999 Page 14 14
SCHEDULED MAINTENANCE
BEFORE EACH USE...
Check the oil level in the Compressors DAILY before using.
The Oil Level Sight Tubes can been seen by shining a light into the bottom, middle of the side perforated
panels in the lower section of the TC2670.
The oil levels should simply be visible in the tube, not more than one inch up.
If oil is not visible or is higher than one inch in the tubes call Technical Support at 800-468-2321.
MONTHLY...
Clean the Condensers to maintain high efficiency performance of the TC2670. Disconnect power and
remove the lower front perforated panel and blow compressed air through the cooling fins of the Condenser
to remove any debris.
Do not bend the fins on the Condenser coils. Air flow will be restricted and cause damage to the TC2670.
Replace the panel before applying power to the TC2670.
FILTER MAINTENANCE
Monitor the Moisture Indicators for a color change from BLUE to PINK. When the TC2670 is new and
immediately after changing Combo Filters, the Moisture Indicators may show PINK. This is due to the
exposure to air and does not indicate inadequate filter performance.
Four Combo Filters are installed on the rear of the TC2670, two for each side.
Both Filters for one side must be changed yearly OR when the Moisture Indicator shows "Wet".