Wright Serial 54956 and higher - Manual (Page 6)

6
1 Introduction
This mower is built to the highest standards in the industry. However, carelessness or operator
error may result in serious bodily injury or death. Accident and hazard prevention are dependent
upon the awareness, concern, wisdom, and proper training of the personnel involve in the
operation, transport, maintenance, and storage of the equipment. Make sure every operator is
properly trained and thoroughly familiar with all of the information in this manual before operating
the equipment.
This machine is constructed only for mowing grass on lawns without obstacles such as stones, tree
stumps etc. The machine can also be used for other tasks when equipped with special accessory
attachments; Grass Gobbler, Velke Sulky and JRCO attachments. All other types of uses are
incorrect. The manufacturer’s directions concerning operation, maintenance and repairs must be
carefully followed.
Lawn mowers and all power equipment, can be potentially dangerous if used improperly. Safety
requires good judgment, careful use in accordance with these instructions and common sense.
The machine must only be operated, maintained and repaired by persons familiar with the
machines special characteristics and who are also knowledgeable about the safety instructions.
Use only approved repair parts to maintain.
Accident prevention regulations, other general safety regulations, occupational safety rules, and
traffic regulations must be followed without fail.
Unauthorized modifications to the design of the machine will absolve the manufacturer from liability
for any resulting personal injury or property damage.
This machine is not intended for use in extreme environments, as a tow vehicle, on steep slopes
greater than 15 degrees or in an enclosed area without good ventilation.
1.1 Technical Data
Weight of overall machine: 32” = 415 lbs, 36” = 425 lbs, 48” = 435 lbs
Machine dimensions: 32” = 74” L x 33.5” (43.5”) W x 41” H
(Chute deflector down) 36” = 79” L x 36.5” (46.5”) W x 41” H
48” = 70” L x 49” (59”) W x 41” H
Speeds: Fwd 4.5 mph, Rev 1 – 3 mph
1.2 General Safety Rules
The Wright Velke Gear Drive Pistol Grip is designed with your safety in mind. It has the following
safety systems with which should become familiar:
•
The warning decals on the mower including general warning decal.
•
Do not disable any of the safety features.
•
The blade switch must be “Off” before starting the engine.
•
You must have your hand holding down the handle bar safety arm to engage the blades.
•
If you let go of the handle bars while the blades are running the engine will stop and the blades will
brake in seconds.
•
If using a Velke Pro 1, X2 or SuperPro attachment, you must step off of the attachment when
backing.
•
Spring loaded chute deflector will help reduce trajectory of thrown objects.
•
Belt/Pulley covers on cutter deck.
•
Low center of gravity (CG) to improve stability on hills.