Wright Serial #55142 and higher - Manual (Page 26)

24
ROLLOVER MAY CAUSE PERMANENT INJURY OR DEATH.
•
ROPS RAISES THE CENTER OF GRAVITY AND REDUCES STABILITY ON SLOPES.
•
SUDDEN STARTS OR TURNS ON RAMPS OR SLOPES CAN CAUSE OVERTURN.
•
USE GREATER CARE ON RAMPS AND AS SLOPES INCREASE.
6.10 ROP’s Installation & Operation
- P/N 98210001 / FORM NO. 98210012
IMPORTANT when using a ROPS:
1. DO NOT cut, drill, modify or repair ROPS in any manner.
2. Always replace a damaged ROPS.
3. Always use the seatbelt and ROPS together.
4. Frequently inspect roll bar and seat belts for damage or loose hardware.
5. Use extreme care when working close to fences, ditches, trees and on hills.
6. Check overhead clearances carefully before driving under any objects.
7. DO NOT leave operator’s position while unit is running.
8. DO NOT carry riders.
9. If ROPS is a folding ROPS, ROPS should be in the upright position and pinned when operating the
machine.
10. See safety Notice below;
ROPS Safety Notice
WARNING! This ROPS is certified for use on machines with a maximum gross vehicle
weight (GVW) of 2300 LBS. The GVW INCLUDES the weight of the base machine,
operator, fuel, ROPS, and other attachments and payloads. When attachments are added,
causing the GVW of the machine to be more than 2300 LBS., the ROPS may not provide
adequate protection resulting in serious injury or death. Use caution when installing
attachments and DO NOT EXCEED the GVW rating of the ROPS.
WARNING!
SERIOUS INJURY OR DEATH MAY RESULT FROM
MACHINE ROLLOVER
• DO NOT OPERATE MACHINE ON STEEP SLOPES OR
NEAR DROP OFFS
• ALWAYS USE SEAT BELTS
• AVOID SHARP AND/OR QUICK TURNS
• DO NOT EXCEED THE MACHINE WEIGHT RATING OF
THE ROPS
WARNING