Wright Serial #55142 and higher - Manual (Page 17)

15
4.6 Deck Lift Lever
The foot operated deck lift is used to raise and lower the deck.
Deck is to be in the up position when in transport, go over curbs,
loading and unloading on to a truck or trailer.
4.7 ROP’s
A Roll Over Protection System (ROP’s, P/N 98210001) and seat belt is provided with the Wright Mid-Mount
Z. Do not remove the ROP’s and the seat belt.
•
Inspect ROP’s and seat hardware every 6 months for loose or
missing hardware.
•
Inspect the seat latch to make sure it is functioning properly.
•
Make sure Retaining ring and clevis pin are fully installed and
lanyard is in good condition
•
Keep ROP’s fully extended
•
Do not jump if machine tips
•
Use seat belt
4.8 Safety Switch System
The Wright Mid-Mount Z is equipped with a safety interlock system. The PTO must be disengaged, brake
applied and control levers in the neutral (Out) position in order to start the machine.
Deck
Lift
Lever
ROP’s
Retaining
Ring
Clevis
Pin
Brake Safety Switch
Brake must be applied to
start and to leave the seat.
Control Handle Safety switch
Control handles must be in the
out position to start the mower
and to leave the seat
Seat Safety Switch
Operator must remain seated
while blades are engaged. To
leave the seat, the brake must
be applied and the control arms
moved to the outward position