Pfister VBP-C10W - Manual (Page 2)

ENGLISH
ENGLISH
WAX SEAL INSTALLATION
2
BIDET INSTALLATION
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price
Pfister recommends calling a qualified plumber if you are uncertain about installing
this product!
This product should be installed in accordance with all local and state plumbing and
building codes. Vitreous china is heavy and fragile. Use extreme care with all
parts!
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
behind the toilet or near the water meter. If you are replacing an existing toilet, remove
the old toilet from the floor and clean the finished floor surface thoroughly.
3 TOOLS RECOMMENDED
• Silicon sealant • Slotted screwdriver • Adjustable wrench
• Pliers • Electric drill • Cloth
• Measuring Tape • Safety glasses • Jigsaw
Your installation may require new supply lines and / or shut-off valves or other
additional tools.
4 INSTALL NEW WAX SEAL (Ground Flange Outlet)
Carefully turn Bidet upside down. On a Secure Padded Surface. Place wax seal (4A)
firmly into the outlet of the toilet bowl.
5 BIDET INSTALLATION
Apply a bead of sealant around the base of Bidet (5A). Very carefully set the Bidet’s Base
(5B) over the ground flange outlet fixture.
Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to pro-
vide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
Place the Plastic Washer (6A) and Metal Washer (6B) on the Mounting Bolt (6C).
Secure by tightening the Mounting Nuts on to the Mounting Bolts.
Caution: Do not over tighten! Finish by snapping on Plastic Caps (6D) over bolts and
nut as shown.
5
6
2
4
4B
5A
4A
5B
6A
6B
6C
6D