En g li sh – Pfister 016-2DFC User Manual

Page 2

ENGLISH

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to

provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow

illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price Pfister

recommends calling a professional if you are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

WARNING: This product has been designed for use with the Price Pfister 15-3WD

(Not included, order separately) series diverter valve. It will not work with any other

product. Please review the 15-3WD series diverter valve installation instructions before

installing this product.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually

found near the water meter. If you are replacing an existing unit, remove the old unit

and clean the mounting surface thoroughly.

3 TOOLS RECOMMENDED

• PTFE plumber's tape or thread sealant

• Philips head screwdriver

• Adjustable wrench

• Flashlight

• Cloth

Your installation will require a pipe nipple for the spout installation as well as other

additional tools.

4 CHECKING THE CONTENTS OF THE BOX

Upon opening the box, check to ensure that all of the following items are included.

A Hand Shower

B Hose

C Wall Mount

D Drop Elbow

E Handle

F Retainer Sleeve

G Washer

H Trim Flange

J Hex Wrench

K Set Screw

L Screws (2X)

M Anchors (2X)

If any of these items are missing, please contact Price Pfister Consumer Service at

1-800-Pfaucet (1-800-732-8238).

5 VALVE LOCATION

Be sure that Diverter Valve Body (5A) is positioned correctly in wall, where the Supply

Valve Shower Outlet is to connected to the Diverter Valve Body Inlet (5B). Be sure that

Primary Outlet (5C) and Secondary Outlet (5D) connections are properly connected.

Center Hole (5E) on wall is 2.00” Dia.

6 COVER REMOVAL

Remove Plastic Cover (6A) from Diverter Valve Body (6B).

2.00” Dia

SECONDARY

OUTLET

PRIMARY

OUTLET

INLET