En g l is h english – Pfister 808-TMKK User Manual

Page 3

ENGLISH

ENGLISH

7 TRIM FLANGE ATTACHMENT

Position Flange (7A) on Valve (7B) with Drain Hole (7C) at the bottom. Place

Protective Washer (7D) on the short end of the reversible Retainer Sleeve

(7E). Screw Retainer Sleeve (7E) onto threaded section of the Stem and

Bonnet (7G). Tighten Retainer Sleeve (7E) by hand until Flange (7A) is snug

to fi nished wall surface. If the short end of the Retainer Sleeve (7E) is too

short, reverse it to use the longer end.

8 HANDLE ATTACHMENT

Screw Stem Extender (8A) onto the Valve Stem (8B). With valve in “CLOSED”

position, place Handle Hub (8C) onto Cartridge (8D) and secure with Screws

(8E). Place Knob (8F) into Handle Hub (8C) and tighten the Set Screw (8G)

by using the Hex Wrench (8H) that is provided. Hand tighten Decorative Lever

(8J) onto Handle Hub (8C).

10 SPOUT INSTALLATION

Apply PTFE plumbers tape on both ends of Pipe Nipple (10A) (not included).

Screw Pipe Nipple (10A) into the elbow inside the wall and tighten with pipe

wrench. The Pipe Nipple (10A) is to project 3

⅞

” to 4” from the fi nished wall.

Screw Tub Spout (10B) onto Pipe Nipple (10A) and tighten until Spout is properly

positioned and fl ush to the fi nished wall.

9 SHOWER ARM INSTALLATION

Insert the longer end of Shower Arm (9A) through the Shower Flange (9B).

Apply PTFE plumber’s tape to both ends of Shower Arm (9A) according to

manufacturer’s instructions. Screw the end of Shower Arm (9A) into pipe elbow

inside the wall. Slide Shower Flange (9B) tight to the wall.

11 UNIT START UP

Turn on hot and cold water supplies, and check all connections for leaks.

10A

” to 4”

10B