Asus P5K WS - Manual (Page 82)

4-20 Chapter 4: BIOS setup
South Bridge Voltage [Auto]
Configuration options: [Auto] [1.05V] [1.20V]
4.4.2 Ai Net 2
This menu displays the status of the Local Area Network (LAN) cable connected to
the LAN (RJ-45) port.
The USB Devices Enabled item shows auto-detected values. If no USB device
is detected, the item shows None.
Select Screen
Select Item
+-
Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
USB Configuration
USB Devices Enabled:
None
USB Functions [Enabled]
USB WIFI Card [Enabled]
USB 2.0 Controller [Enabled]
USB 2.0 Controller Mode [HiSpeed]
BIOS EHCI Hand-off [Enabled]
Port 64/60 Emulation [Disabled]
Legacy USB Support [Auto]
Options
Disabled
Enhanced
4.4.3 USB Configuration
The items in this menu allows you to change the USB-related features. Select an
item then press to display the configuration options.
Select Screen
Select Item
+-
Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
POST Check LAN cable [Disabled]
Ai Net 2
Pair Status Length
1-2 N/A
3-6 N/A
4-5 N/A
7-8 N/A
1-2 N/A
3-6 N/A
4-5 N/A
7-8 N/A
Options
Disabled
Enhanced
POST Check LAN cable [Disabled]
Allows you to enable or disable LAN cable check during POST. When enabled, the
menu reports the cable faults or shorts, and displays the point (length) where the
fault or short is detected. Configuration options: [Disabled] [Enabled]