Proface FP3900 - 19 Flat Panel" - Manual (Page 3)

-3-
Installation
Panel Cut Dimensions
The USB plug side of a cable is attached in Display. Attach the packing, the cap (the
packing part), the nut, and the cap (the main part) carefully as shown below with confirming
that they are not bent or twisted.
Please adopt the figure on the left side in the figures shown above. If the figure on the right
side is adopted, efficiency of waterproof might be reduced.
• If the cap is attached to this cable, IP65f will be applied to the
front side (the right side of the panel in the figures above) only.
• Tighten the cap. Tighten the nut with the torque (0.1N•m). If the
torque is too strong or weak, efficiency of waterproof may not be
fully made.
Panel(1.6 to 4.0 [0.06 to 0.16])
Packing
Nut
Waterproof Cap
Unit:mm[in.]
19.4 ± 0.1[0.76]
Unit:mm[in.]
φ
20.8
±
0.1[0.82]
φ
20.8
± 0.1[0.82]