Val-Matic 2-12 in. (DN 50-300 mm) Wafer Style Dual Disc Check Valve - Manual (Page 6)

REASSEMBLY (Continued)
8. Install one of the four retainer set screws (7) & (8)
into each the tapped pin bores, and tighten into
place. The retainer set screws are metric and
should be installed using standard metric hex drive
bits or wrenches. The screws should be tightened
until they are about one turn past the point of
being flush with the exterior surface of the valve
body.
LIMITED WARRANTY
All products are warranted to be free of defects in material and workmanship for a period of one year from the date of
shipment, subject to the limitations below.
If the purchaser believes a product is defective, the purchaser shall: (a) Notify the manufacturer, state the alleged defect and request
permission to return the product; (b) if permission is given, return the product with transportation prepaid. If the product is accepted
for return and found to be defective, the manufacturer will, at his discretion, either repair or replace the product, f.o.b. factory, within
60 days of receipt, or refund the purchase price. Other than to repair, replace or refund as described above, purchaser agrees that
manufacturer shall not be liable for any loss, costs, expenses or damages of any kind arising out of the product, its use, installation
or replacement, labeling, instructions, information or technical data of any kind, description of product use, sample or model,
warnings or lack of any of the foregoing. NO OTHER WARRANTIES, WRITTEN OR ORAL, EXPRESS OR IMPLIED, INCLUDING THE
WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY, ARE MADE OR AUTHORIZED. NO
AFFIRMATION OF FACT, PROMISE, DESCRIPTION OF PRODUCT OF USE OR SAMPLE OR MODEL SHALL CREATE ANY WARRANTY
FROM MANUFACTURER, UNLESS SIGNED BY THE PRESIDENT OF THE MANUFACTURER. These products are not manufactured,
sold or intended for personal, family or household purposes.
9. Stand the valve on its edge with the pins vertical,
and verify smooth operation of the valve before
installation into the pipeline. Apply a light coat of
silicone grease on the rubber seat for air service
valves (Series 8900).
PARTS AND SERVICE
Parts and service are available from your local
representative or the factory. Make note of the
Valve Size and Model Number located on the valve
nameplate and contact:
Val-Matic Valve and Manufacturing Corp.
905 Riverside Drive
Elmhurst, IL 60126
Phone: (630) 941-7600
Fax: (630) 941-8042
www.valmatic.com
A sales representative will quote prices for parts or
arrange for service as needed.
®
VAL-MATIC ® VALVE AND MANUFACTURING CORP.
905 RIVERSIDE DR. ELMHURST, IL. 60126
TEL. 630 / 941-7600 FAX. 630 / 941-8042
5