Rapid-Air PALLET MASTER (PMD) HIGH SPEED: 35, 50 & 100 SERIES - Manual (Page 4)

Operation
12. Place the coiled stock on the turntable. Center the material on the turntable within 1/2 inch
from center.
13. Rotate the table slowly by pushing the control arm toward the turntable. Unwind the first
coil until the material can be threaded around the roller and back toward the press. The con-
trol arm and turntable will, now, operate automatically.
14. Slowly walk the material to the press. An alternate means of moving the material toward
the press is the Run/Stop/Jog switch in repetitive Jog actuations. This may be a preferred
method since this function overrides the control arm that may not be properly set at this
time.
15. Run/ Stop/ Jog - “STOP”
16. Adjust the roller angle so that the material makes full contact.
17. Adjust the height of the control arm.
18. Adjust the counter weight to just offset the affect of the material loop so that the control arm
will go back to the starting (rest) position when the press is not demanding material. (Refer
to Inst #24 for loop height.)
Control Adjustments
19. Run/Stop/Jog: (see inst. #14)
20. Rotation directions: (see inst. #5)
21. Loop Range: This switch selects the sensitivity of the control arm travel from minimum to
maximum speed in a narrow to a wide range depending upon the arm length of the control
arm and press material demand.
22. Loop Height: This switch sets the start position in the arc of the control arm as it swings off
of its mechanical stop.
(see dia. next page)
4