Dancer arm adjustment explanation – Rapid-Air STRAIGHTENER and PUSHBUTTON RAPID-ROLL: SC SERIES User Manual
Page 8

JOG SPEED AND DANCER SET-UP
The straightener was shipped with
the dancer arm set up for its correct
position so the only thing that has to
be reset would be the jog speed if you
need it to jog faster or slower. The
rest of the keypad is pretty much self
explained so become familiar with the
keypad positions for making adjust-
ments on the fly. Turn on the main
power switch and select “LV” for loop
arm vertical at “Loop Type” on the
pushbuttons.
MAkING INTERNAL
PROGRAM ADJUSTMENTS
Turn off the main power switch,
press and hold the “Run/Stop/Jog”
button while turning the main
power switch on. The first screen
you see will display the jog speed
percentage.
JOG SPEED
23% +
NEXT
-
If you want the jog speed faster
then press the “Reel Speed “+ ““ %
speed pushbutton. If you want the jog
speed slower then press the “Reel
Speed “-”” % speed pushbutton. The
jog speed is shown in percent of max
jog speed. If the jog speed is “OK “
then push the “Run/Stop/Jog button”
once for next.
The next screen asks if you want to
set up the sensor. As before the per-
cent speed buttons are used for the
yes-no. Select “no” if all you wanted
to do was set the jog speed. Select
“yes” if you want to reset the dancer
arm position setup. And then “next”.
SETUP SENSOR
YES
NEXT
NO
The next screen asks you to set the
low set point. If the dancer arm is at
“No Material Rest” then just save
the setting by pushing the Stop/Run
Jog pushbutton.
SENSOR LOW SETPOINT
SAVE
XXX
The next screen is for setting the high
set point. Raise the dancer arm to
its upper stop position and press the
save or Stop/Run/Jog button once.
SENSOR HIGH SETPOINT
SAVE
XXX
The next screen is to set the offset of
the program. Potentiometers are hard
to get set from left to right so we built
in an offset. If you set the low and
high range and go into run and the
reel runs for no reason then an offset
has to put in. Go through the setup
procedure again and put in an offset
of –3 to –5 and now the pot is zero.
LOW OFFSET + 0 +
NEXT
-
You have now set the dancer arm
limits. The next screen is to exit the
setup and start working
EXIT SETUP?
YES
NO
Choose yes and next and the next
screen appears .
SHUT OFF POWER TO
SAVE AND EXIT
The dancer arm is now ready for
production running.
dancer arM adjuStMent explanation