Rapid-Air SERVO FEED WITH CUT-TO-LENGTH: 100, 200 & 300 SERIES User Manual

Page 19

If the F2 key was pressed then the servo will be in the auto total mode and the
following screen appears.

AUTOMATIC TOT=000000
JOB# =00 CUT=0.150
FL=000.000 SPEED=100
ACCEL=001% F4=RETURN

Pressing the F4 key, stops the automatic cycle and the main menu screen appears.

MAIN SELECTION MENU
F1=JOB # F2=MANUAL
F3=AUTOMATIC CYCLE
F4=REVIEW JOB PROGRAM

F3=AUTOMATIC CYCLE
If the feed has been properly set up, tested in manual, press electrically interlocked
with feed, feed and pilot switches wired to the correct terminals, then pressing the F3
key will display the following screen.

SELECT CONTINUOUS OR
BATCH CYCLE F1=BATCH
F2=CONTINUOUS CYCLE
F4=EXIT TO MAIN MENU

F1=BATCH
If the F1 key was pressed then the servo will be in the auto batch mode and the
following screen appears.

BATCH SETTING=000000
BATCH COUNTER=000000
F1=RESET BATCH COUNT
F4=CONTINUE WITH COUNT

If F1 (reset batch count) is pressed then the batch count will be reset to it’s preset
valve. If F4 (continue with count) is pressed the batch count will remain at its present
value. Either F1 or F4 will lead to the following screen.

AUTOMATIC BATCH=000000
JOB#=XX CUT=0.XXX
FL=XXX.XXX SPEED=XXX%
ACCEL=XXX% F4=RETURN