Rapid-Air SERVO FEED WITH CUT-TO-LENGTH: 100, 200 & 300 SERIES User Manual

Page 18

JOG! TYPE=CONTINUOUS
F1=ALTER TYPE OF JOG
F2=FORWARD F3=BACKUP
F4=EXIT (INCH MODE)

Pressing the F4 key once will reset the program to the jog mode screen so that jog is
now active. Pressing the F4 key twice will reset the program to the manual mode
screen. If the F4 key was pressed twice then the following screen is displayed.

MANUAL MODE F1=INCH
F2=SINGLE FEED MODE
F4=EXIT MANUAL MODE
CYCLE ROLL WITH KEYS

F2=SINGLE FEED

If the operator presses F2 then the following screen is displayed. The single feed
mode is active and every time the F1 key is pressed then the feed will cycle and move
the distance indicated on the feed length line.

JOB#=00 FL=000.000
F1=FEED SINGLE LNGTH
F2=CUT F3=SINGLE CYC
F4=EXIT (SINGLE FEED)

Pressing F4 once resets the program to the manual mode display. Pressing the F4
key twice resets the program to the main menu display. If the F4 key was pressed
twice the following screen is displayed.

MAIN SELECTION MENU
F1=JOB # F2=MANUAL
F3=AUTOMATIC CYCLE
F4=REVIEW JOB PROGRAM

F3=AUTOMATIC CYCLE

You can now select between batch or continuous mode

SELECT CONTINUOUS OR
BATCH CYCLE F1=BATCH
F2=CONTINUOUS CYCLE
F4=EXIT TO MAIN MENU

F2=CONTINUOUS