Rapid-Air SMART MINI-SERVO FEED: SMS2, SMS4, SMS8 - Manual (Page 10)

0
ProGramminG ProCedUre
(ContinUed)
F2, reset totals, on the “SET COUN-
TER VALUES” screen resets the total
counter to 000000.
F6, exit, will return to the “RAMP/
COUNTER” screen.
F2, speed/acc/dec, on the “RAMP/
COUNTER” screen leads to:
EXIT
ALTER PERCENTAGES
%ACC %DEC %SPEED
F6, exit, will return to the “RAMP/
COUNTER” screen.
F1, % acc, allows the acceleration
percentage to be altered with:
ENTER PERCENT OF ACC
MAX ACCEL = 000 %
MAXIMUM RATE (1 - 100) %
ENTER kEY TO EXIT
The enter key returns the display
to the “ALTER PERCENTAGES”
screen.
F2, % dec, allows the deceleration
percentage to be altered with:
ENTER PERCENT OF DEC
MAX DECEL = 000 %
MAXIMUM RATE (1 - 100) %
ENTER kEY TO EXIT
The enter key returns the display
to the “ALTER PERCENTAGES”
screen.
F3, % speed, allows the speed per-
centage to be altered with:
ENTER PERCENT OF SPEED
MAX SPEED = 000 %
MAXIMUM RATE (1 - 100) %
ENTER kEY TO EXIT
The enter key returns the display to
the “ALTER PERCENTAGES” screen.
SECTION 6 F6 - CYCLE ROLLER
F6, cycler roller, on the“MAIN
MENU” screen displays the following
screen.
EXIT
CYCLE FEED ROLLERS
OPEN CLOSE
ROLLER ROLLER
This allows the operator to manually
open and close the rollers.
SECTION 7 “.” - END OF FEED
Pushing a “.”, end of feed, while in the
“MAIN MENU” screen displays the
following screen:
END OF FEED DURATION
ENTER 0.000 FOR NONE
END FEED TIME=0.000
This allows the operator to set the
duration of the END OF FEED OUTPUT.
The default duration of outputs is 250
milliseconds. Please refer to the wir-
ing schematic for the locations of the
END OF FEED OUTPUT.
SECTION 4 F4 - JOB VALUES REVIEw
F4, job values, on the “MAIN MENU”
screen displays the following screen
until F6, exit, is pushed. This screen
lists the current active job number,
the feed length, the SPM, the per-
centage of speed, the percentage of
acceleration, and if a pilot is used.
JOB # 00 VALUES =
FEED LENGTh = 00.000
SPM = 000 % SPEED = 000
%ACCEL = 000 F6 = EXIT
SECTION 5 F5 - RAMP/COUNTER
F5, ramp/counter, on the “MAIN
MENU” screen displays the following
screen:
EXIT
BATCh/ SPEED/
TOTAL ACC/DEC
F1, batch/total, on the
“RAMP/COUNTER” screen leads to:
EXIT
SET COUNTER VALUES
SET RESET
BATCh/ TOTAL
F1, set batch, on the “SET COUNTER
VALUES” screen leads to “BATCH
SET” screen discussed above in
SECTION 3.