Arcam Blu-Ray Disc Player BDP300 - Manual (Page 12)

E-12
CR104
SHIFT
CANCEL
TV
AV
RND
CH
STATUS iPOD
HDMI NET
RPT
BD
CD
AV
TUN
PVR VCR
SAT
AMP
MODE MENU
RTN
BASS EFFECT EQ DIRECT
TRIM TREBLE ANGLE/SUB SYNC
SRCH
SETUP TITLE AUDIO SUBT
INFO FAV + FAV - HOME
DISP
remote
control
The CR104 remote
The CR104 is a sophisticated ‘universal’ remote control
that can control up to eight devices – including the
BDP300. As it’s a ‘learning’ remote, it can copy almost
any function from an existing single-device remote.
You can also program the CR104 to issue a sequence of
commands (‘macros’) from a single button press.
Select the source key first
Remember to select a source key before pressing
command buttons – commands vary depending on the
source selected.
To operate the BDP300 from the remote, first press the
BD source button.
TUN AV SAT
CD PVR VCR AMP
BD
On/Standby
This allows the BDP300 to be put into and taken out of
standby remotely.
Navigation buttons
Arrow buttons allow navigation around the settings
menus on the BDP300 and disc menus.
Confirm a selection by pressing O.
Numeric keys, 0–9
Used for data entry. Also gives direct access to
individual tracks on audio CDs.
VOLUME +/–
Adjusts the volume of an Arcam amplifier.
MODE
This button activates the Picture-in-Picture Secondary
Video function, where available.
DISP (display)
Press to cycle through the front panel display’s
brightness options (dim to bright, off).
0 /
Press to skip backwards to the previous track( 0 ) or
forwards to the next track ( / ).
MENU
Activates the BD ‘popup’ menu or the DVD Video
menu.
RTN
Navigates to the previous menu.
RND
Toggles random (‘shuffle’) play of chapters/tracks on
and off.
Press S followed by r to cycle through repeat play
options (chapter, title, disc, etc.).
Source selection and handset configuration
BD BD input/BD controls
SAT Satellite decoder input/SAT controls
AV Television (sound) input/AV controls
TUN Radio tuner input/TUN controls
AMP Arcam amplifier
PVR Personal Video Recorder input/controls
VCR Video Cassette Recorder input/controls
CD CD player input/CD controls
Press the relevant button once to select input and
reconfigure the handset.
Press and hold the button until the power LED blinks
once if you wish to reconfigure the handset without
changing the input.
Advanced controls
These buttons are described on the next page.
MUTE
Press once to mute an Arcam amplifier. Press again (or
use +/– volume) to un-mute.
OPEN
Opens and closes the disc tray.
SETUP
Press
SETUP to access the system settings menu.
Playback control
Play (
4 ), Pause ( ; ) and Stop ( < ).
SHIFT + ; activates slow playback.
STATUS
Toggles the disc information display.
Press s followed by
STATUS to cycle through the HDMI
output resolutions (only available from the Home
screen).