Qualcraft Stacker Bracket Frame - Manual (Page 11)

G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
9
2. Nail selected 2” x 4”, 3’ Support Brace to Support Bracket at layout mark. DO NOT drive nail
flush, as it must be removed during disassembly. Support Bracket might not always be centered
on Support Brace. DO NOT nail Support Brace to wall.
3’ long, 2” x 4” Support Brace
MUST cross MINIMUM
3 wall studs
3. Attach Top Clamps to paired Support Brackets: 1) Ensure Top Clamp is sized correctly for
applicable installation location; 2) Turn Threaded Bolt Nut until snug to secure Threaded Bolt in
Top Clamp Housing (nut MUST NOT be installed on opposite side of Support Bracket); 3) Apply a
small amount of thread lubrication to Eyebolt; 4) Insert Top Clamp Peg and Threaded Bolt
through corresponding Support Bracket holes; 5) Use a socket wrench to tighten Threaded Bolt
until it is fully secured in Support Bracket. DO NOT insert Hitch Pin until after Eyebolt is tightened
onto rail (see: steps 7 and 8).
Hitch Pin
Threaded Bolt
Eyebolt
Top Clamp
Top Clamp Peg
Threaded Bolt
Sheathing
Threaded Bolt Nut