Qualcraft Clone Universal Rolling Scaffold User Manual
Page 9
G
G
u
u
a
a
r
r
d
d
i
i
a
a
n
n
F
F
a
a
l
l
l
l
P
P
r
r
o
o
t
t
e
e
c
c
t
t
i
i
o
o
n
n
2
2
6
6
6
6
0
0
9
9
7
7
9
9
t
t
h
h
A
A
v
v
e
e
.
.
S
S
.
.
,
,
K
K
e
e
n
n
t
t
,
,
W
W
A
A
9
9
8
8
0
0
3
3
2
2
8
8
0
0
0
0
-
-
4
4
6
6
6
6
-
-
6
6
3
3
8
8
5
5
Page 9
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S:
Assembly of The FramePro 6’ Multifunction Scaffold
1. Invert an End Frame Access Ladder. Insert the casters into the ladder leg bushings,
pressing the casters into the bushing by hand until the hole in the caster stem lines up
with the hole in the scaffold ladder. Secure the casters using the provided clevis pins.
Repeat this process for the second End Frame Access Ladder.
2. Turn the End Frame Access Ladder over so that it rests on its casters. Holding an End
Frame Ladder with one hand, engage one truss to the ladder leg. Secure the truss by
using the provided clevis pin.
3. Hold the second End Frame Access Ladder with one hand. Repeat Step 2 to attach the
other end of the truss to the second End Frame Access Ladder.
4. Attach the second truss to the partially assembled scaffold. Make sure both truss are
the same height and parallel to the floor. Secure the truss by using the provided clevis
pins.
5. Set the scaffold upright. Make sure the brakes on the casters are set.
6. Complete the assembly by laying the platform in place, resting it securely within the
platform ledges of each truss channel. No metal platform should be visible above the
vertical lip of the truss channel. Make sure the platform ledges on the truss channel are
thoroughly cleaned and free for debris that would prevent the platform from seating
properly into the trusses.
Assembly of the Guardrails
Note: Guardrails shall be used at working platform heights of 6 feet or higher. (OSHA 1910.28,
1910.29 and ANSI Z359.1-2007) Check with state and local codes or private company directives
for variances with may be more restrictive than federal coders.
1. Take the Fixed End of the Guardrail and attach one Truss securing it with the provided
Clevis Pin.
2. Take the other Truss and attach it to the other side of the Fixed End of the Guardrail
securing it with the provided Clevis Pin.
3. Repeat this process with the Access Point End of the Guardrail.
4. Install guardrail by inserting four corner pegs in their corresponding receivers on the
scaffold. Secure each peg with the provided Clevis Pins.