Poly-Tex SUNSTOPPER shade structure system - Manual (Page 11)

FIGURE 5
BUNGEE INSTALLATION
REV: AE-131121
8
INSTRUCTIONS:
CAUTION: WEAR EYE PROTECTION WHEN
INSTALLING BUNGEE CORDS.
1. Insert Bungee Cord through Grommet in fabric.
2. Wrap cord around support.
3. Insert ball through loop.
4. Once in place, move Bungee so that ball is over
the Grommet as shown.
5. A Bungee may slip off if not installed properly.
Occasionally check installation to insure that all
Bungee Cords remain attached.
6. When re-installing, inspect Bungee balls for
wear or damage.
Do not use damaged Bungee Balls!
7. For adjacent shade panels, use only one
Bungee Ball per Grommet as shown in
FIGURE 5.
DO NOT USE ONE BUNGEE BALL FOR TWO
GROMMET HOLES.
1
2
3
4
1
2
3
4