Poly-Tex SUNSTOPPER shade structure system - Manual (Page 10)

DIAGONAL CABLE INSTALLATION
7
REV: AE-131121
FIGURE 2
FIGURE 1
INSTRUCTIONS:
1. Remove one Ø5/16" Hex Nut from the inside of one corner fitting (FIGURE 1).
Do not discard.
2. Attach the bracket on the non-turnbuckle end of the cable assembly to the top fitting as shown
in FIGURE 1 using the Ø5/16" x 3-1/2" long Hex Bolt and replace Nut and Washer.
3. Unscrew the turnbuckle to make the cable assembly as long as possible.
4. Remove one Ø5/16" Hex Nut from the inside of the corner fitting on the opposite corner
of the 20' x 20' section.
5. Attach the bracket on the turnbuckle end of the cable assembly to the top fitting as shown in
FIGURE 2 using the previously removed Ø5/16" x 3-1/2" long Hex Bolt and replace Nut and Washer.
6. Tighten the cable assembly with the turnbuckle until the cable has about an 8" sag.
8" "Sag"
SEE FIGURE 1
SEE FIGURE 2