Pacific Laser Equipment 1SA-1000 - Manual (Page 13)

Servo Amplifier 1ch-1000 User manual
1SA-1000
April 28, 2004 Release: 1.21 2003 by Pacific Laser Equipment
PLEquipment, 3941 S. Bristol St. Unit E, # 122, Santa Ana, CA. 92704, ( & Fax: 509-355-5155, Email: [email protected]
Page 13 of 16
7. Technical specs
7.1 Electronics
Output voltage range 0V to -1200V DC (negative polarity).
Position feedback from strain gage sensor (SGS).
Display: 3 ½ digit LED display.
Analog input: 0 to 10V for 0 to nominal actuator e xpansion (pre-calibrated).
Monitor out: 0 to 10V for 0 to nominal actuator expansion (pre-calibrated).
Servo controller: Proportional / integral term controller.
Power out: 3W continuous, 5W peak.
Static operation: The SGS offers long-term stability in the range of 90nm.
Dimensions: 8.5 x 6.15 x 3.1”
Power requirements: 120V AC, 100mA.
Dimensions: 8.5 x 6.15 x 3.092 inches
Enclosure material: Aluminum (Black anodized)
7.2 Piezo actuator type 90P1000 ( Vacuum compatible to 10E-6 torr )
Displacement: 90
µ
m
Dimensions: L ~ 77mm, Dia ~ 12mm
Feedback sensor: Strain Gage Sensor (SGS)
Max. push force: 50N
Max. pull force: 1N
Max. bending moment: 0.1Nm
Max. twisting moment: 0.1Nm