beautypg.com

Autostart AS-1252 User Manual

Page 5

background image

User Guide

P. 5

Valet Mode using the Valet Button (If installed)
To put the system into valet mode:

1. Turn the key to the

IGNITION ON (RUN)

position.

2. Within 3 sec., press the valet button for 1 second.

The parking lights will flash three times to indicate that the vehicle is now in valet mode.

3. Turn the key to the

OFF

position.

The LED on the antenna will come

ON

solid.

To take the system out of valet mode:

1. Turn the key to the

IGNITION ON (RUN)

position.

2. Within 3 sec., press the valet button for 1 second (the LED will turn

OFF

or start to flash).

The parking lights will flash twice to indicate that the vehicle is now out of valet mode.

The LED will go out or start to flash.
The Valet button can only be used if the vehicle keys are in the

IGNITION ON (RUN)

position.

Panic Mode

Note:

Panic mode can only be activated if the horn option has been adequately installed and

programmed by your installer. Button

Ι has to be programmed as

LOCK

and

UNLOCK

.

In an emergency situation, you can activate panic mode using the

Ι button. This will:

• shut down the engine

• unlock or lock the doors (with the

Ι

button)

• disarm the Starter Kill and

• activate the horn for 25 sec.

Note: See the description of the starter kill option later in this Guide.

To activate panic mode:
• Press and hold the Ι button until the horn honk starts and the parking lights flash: this will

unlock the doors before the sound signal starts.

Or press and hold the Ι button until the horn honk starts and the parking lights flash: this will

lock the doors before the sound signal starts.

Panic Mode will automatically shut down after 25 sec.

Note: To stop panic mode before the end of its delay, press the

Ι button until the sound signal

stops.

Cold Weather Mode

If your vehicle has a manual transmission, Ready mode should be set before entering Cold Weather

mode. When cold weather mode is active, the engine starts every 2 hours and runs for 3 minutes (or 8

or 20 minutes with diesel engines). Cold weather mode automatically ends after 24 hours (or 12 starts).

To enter Cold Weather Mode:

• Press the ΙΙ button for 3 seconds.

• There will be two (2) beeps and the parking lights will flash three (3) times.

Note: You can enter Cold Weather mode the same way on a manual vehicle, as long as the unit is in

Ready mode first.

To exit Cold Weather Mode, do any one of the following actions:

• Open the hood.

• Start the engine by remote.

• Start the engine with the key.

• Press the ΙΙ button for three seconds. (There will be one (1) beep and the parking lights will flash

once.)

Engine Run Time

If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or

25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be programmed

to run the engine for 8, 20, or 30 minutes (20 minutes default).

This manual is related to the following products: