Step 3: attach wheels to axle – Northstar Trailers SPORTSTAR I User Manual
Page 8
![background image](/manuals/357168/8/background.png)
STEP 3: ATTACH WHEELS TO AXLE
Note: the hub assembly comes attached to the wheels with washers and pre-lubricated
bearings. Upon removing the dust caps, take special care to not drop the bearings or
get them dirty.
a. Carefully remove the dust-cap from the wheel (7) by gently prying around
the edges of the cap with a small, flathead screwdriver, or by using a long bolt
to gently drive through the backside of the hub and into the cap.
b. Remove the outer bearing, flat-washer and cotter-key from the interior of the
hub, then set aside.
c. Carefully slide the wheel onto the end of the axle.
d. Slide the bearings into the hub; press into place carefully as to not remove
any grease.
e. Place the flat-washer on the bearing, followed by the castle-nut. Ensure that
the washers are snug with and pressed flat against the bearings.
f. Fully tighten the castle-nut against the bearings to the point that the nut
applies enough pressure against the bearings to lock them into place. Then,
loosen the castle nut approximately ¼”, or to the point where the wheel can
spin; the nut should be loose enough that the wheel freely spins, yet tight
enough that the wheel does not have horizontal play or wiggle. The final
castle-nut tension will be approximately 35 ft-lbs. (Proper tension is critical
to the longevity of the bearings).
g. Insert the cotter-pin through the small hole located near the end of the axle.
Ensure that the pin lies flat inside the castle-nut notches. The cotter-pin
maintains the integrity of the hub and secures the wheel to the axle.
h. Attach a grease gun to the hub’s Zirk fittings, located on the back-side of the
hub, and apply pressure until you can see grease extruding from the bearing
casing.
i. Replace the dust-cap by tapping it into place with a rubber mallet. RTV
sealant or silicon may be applied to the circumference of the dust-cap before
installation to ensure that the cap will not fall off while in tow. Let the sealant
completely dry before towing.