Northstar Trailers SPORTSTAR I - Manual (Page 11)

INSTALL RUNNING LIGHTS
a. The white wire from the harness is not needed for ground on this light and
can be capped off (with wiring connector (R)) or tied to other wires in the
harness with a small zip-tie.
b. Connect the brown wire from the running light (N) with the brown wire from
the wiring harness by pushing the wires together.
c. Position the brown wire under the silver tab, between the tab and the lens.
Run the screw through the silver tab, and then fasten the light to the trailer
using two small brass screws (Q) found in the small bag with the wire
connectors.
Tip: Once you install the lights, pull any excess wire back into the frame.
STEP 7: ATTACH FENDERS
a. Align the fender bolt-holes with the bolt-holes in the frame.
b. Use 1” bolts (J), flat-washers (I) and lock-washers (H) to fasten fender (10) to
the frame