IEI Integration DM_Series v2.04 - Manual (Page 67)

DM Series Monitor
Page 53
5.4.4 12V Power Connector
Use the rear panel +12V DC jack to connect the monitor to a power source.
Figure 5-4: 12V Power Connector
5.4.5 RS-232 Touch Panel Connector
Use the rear panel standard RS-232 DB-9 female touch panel connector to connect the
monitor to the system graphics interface.
PIN DESCRIPTION PIN DESCRIPTION
1 DCD1 6 CTS1
2 DSR1 7 DTR1
3 RX1 8 RI1
4 RTS1 9 GND
5 TX1
Table 5-4: RS-232 Touch Panel Connector Pinouts
Figure 5-5: RS-232 Touch Panel Connector