The AdderLink IP asks for an unknown admin password
This may occur if the AdderLink IP has been previously configured. If the existing
admin password cannot be discovered, then your only recourse is to perform a
factory reset.

To invoke a configuration reset by switch

1 Remove power from the AdderLink IP unit.
2 At the rear of the AdderLink IP, adjacent to the power input socket, click

mini switch 1 to its ON (down) position.

3 Re-apply power to the AdderLink IP. On the locally connected monitor you

should see a Maintenance menu:

AdderLink IP Maintenance

Reset Configuration

return to normal operation.

Configure Network

Put option switch 1 up to

To upgrade unit, visit:

http://192.168.42.154

AdderLink IP Reset Config

DO YOU WISH TO CONTINUE?

Cancel

RESET

WARNING: Continuing will cause
your existing configuration to
be erased.

The unit will then reset and
require re-configuring before
it can be used.

4 Select the ‘Reset configuration’ option.

A warning screen will be displayed. Select the RESET option and press

5 Remove power, return the mini switch 1 to its OFF position and then re-

apply power. The locally connected monitor should display the first screen of
the

initial configuration sequence

The AdderLink IP does not display the configuration sequence
If the AdderLink IP has been previously configured it may not automatically
display the first of the setup screens. In this case you have two options, either:

• Access the Unit, Network and Serial

configuration screens separately

, or

• Reset the configuration:

To invoke a configuration reset by main menu

1 Using the locally connected keyboard and screen, log on as the admin user.
2 Select the ‘Configuration’ option.

AdderLink IP Configuration

Reset Configuration

Back

Modem Configuration

Network Configuration

Unit Configuration