Onnection to, Connection to wan – WansView NCM628W User Manual
Page 10
9
user manual of the router or get the support from router factory);
2) Press WPS/QSS button on the router, it will launch the function.
3) Press and hold on reset button for 2~5 seconds after it ran normally（not need
connect cable）, it will launch the WPS/QSS function, then match the setting with the
router, the status LED always on when it was matching, and it will flash after
matching successfully.
4) Unplug power adaptor and reboot the camera, then you can use the wireless
connect function.
Note: The camera will automatically stop the function when the matching is unsuccessful
after continuing 50 seconds. Due to different kinds of the router, we don’t sure our
camera can be connected to all routers successfully.
2.3. Connection to WAN
You should connect it to LAN network and do the port forwarding at first, and then
connect the LAN network to WAN, connect as figure 6.
Figure 6
For example: operation step of port forwarding as figure 7.
IP camera
LAN computer
WAN computer
Router
ADSL
Internet
IOS
Android