TIF ACL2500 Refrigerant Leak Detector - Manual (Page 12)

3. If the tip itself is dirty it can be cleaned by immersing in a mild solvent, such as
alcohol, for a few seconds, and then using compressed air and/or a shop towel
to clean.
NOTE: Never use solvents such as gasoline, turpentine, mineral spirits, etc... as
these will leave a detectable residue and desensitize your unit.
Sensing tip replacement: The tip will eventually wear out and require replace-
ment. It is difficult to predict exactly when this will occur since tip longevity is
directly related to the conditions and frequency of use. The tip should be
replaced whenever the alarm sounds or becomes erratic, in a clean, pure, air
environment.
To replace the tip:
1. Make sure the unit is OFF.
2. Remove the old tip by unscrewing counter-clockwise.
3. Use the supplied replacement tip, located in the carrying case. Replace
by screwing on clockwise.
Standard Equipment
Your Halogen Leak Detector comes equipped with one Carrying Case, one Owner's
Manual, 2 "C" cell batteries and one replacement Sensing Tip and Protector.
To purchase replacement parts for your leak detector please contact your local dis-
tributor. To ensure that you obtain the correct parts it is best to reference the part
number when placing your order.
Replacement Parts :
TIFXP-2RED
Maintenance Kit (3 Sensing Tips & 3 TIp Protectors)
TIFXP-4AMAC
Blow Molded Carrying Case
TIF5201
Leak Source
10
MAINTENANCE
REPLACEMENT PARTS