TSI IAQ50 - Manual (Page 25)

25
Printing Data Using the Optional
MicroPrinter
If the optional MicroPrinter is connected,
what is viewed on-screen will be on the
paper printout.
Note: In order to print, the baud rate on the
Model IAQ50 must be set to the same as the
printer. The default is 1200.
The data will print in a format such as
12,345.67. If you desire, the Model IAQ50
can print in a format such as 12.345,67 by
switching DIP switch #8 ON. See “DIP
Switch Settings” in Chapter 8.
Connecting the Optional MicroPrinter
To connect the MicroPrinter printer to the
Model IAQ50, locate the Printer Interface
Cable (supplied with the optional printer)
and connect the 9-pin end labeled
“PRINTER” to the printer and the other
end to the data port of the Model IAQ50.
The printer must be set to the same baud
rate as the Model IAQ50. See Baud Rate
section for details on how to change the
baud rate. To change the baud rate of the