Terk FDTV1A_OMЙ - Manual (Page 8)

FD
TV1a
7
Installation
(continued)
Coaxial
Cable
Audio/Video
Cables
Converter Box
FDTV1a Built-In
Coaxial Cable
Amplifier
Insert
ANTENNA
TV/STB
TV
–or–
2. Connect the FDTV1a’s built-in
cable to the input jack of the
amplifier.
3. Connect the amplifier’s cable
to the antenna input on the
converter box.
4. Follow the directions in the
manual that came with your
converter box to connect it to
your TV.
5. Plug the amplifier’s power
cord into an electrical outlet.
Important: This power unit
should be plugged in so that it
stays vertical or lays flat.
6. Run your converter box’s setup
routine to scan for available
broadcast channels.
To connect the FDTV1a with the amplifier to a
converter box or other tuning device:
1. Make sure your converter box is turned off.