Accton Technology EN2024-6 - Manual (Page 27)

Novell NetWare
21
Configuration Settings
This section describes the configuration settings which can be altered in your Print
Server. To make changes, use PSCONFIG or the programs described in
Chapter 8 -
Management Tools.
Configuration using PSCONFIG
To use PSCONFIG to change the device settings, the procedure is as follows.
1. Run PSCONFIG; a list of Print Server units will appear.
2. Select the Print Server you want to setup, then press [E NTER
].
3. Select
Change Configuration. A list of category configurations will appear.
4. Select the category you want to edit, then press [E NTER
].
5. Select the item you want to edit and press [Enter]. If you are prompted to enter a
character string, enter a string.
6. Change any other items you wish. The [E SC
] key will return you to main menu to
select another category if you wish.
7. Select
Execute Change and press [E
NTER
] to save the configuration changes to
the Print Server.
General Device Settings
The following configuration changes can be made, regardless of which Network
protocol or operating systems is being used. :
•
Get Print Server Information
•
Reset Print Server
•
Restore Default Configuration
•
Change the Print Server’s name.
•
Change the device password.
•
Disable/Enable network protocols.
•
Get Printer Status (idle, off-line, printing)
•
Logical Printer Setup (see page 24)
•
Define logical printer
•
Set pre-print-job string.
•
Set post-print-job string
•
Serial port configuration (if exists):
•
Baud rate
•
Handshake protocol
•
Stop bits
•
Data bits
•
Parity.