Asus P4T533-C - Manual (Page 52)

38 Chapter 2: Hardware information
19. Smart Card Reader connector (14-1 pin SMARTCON) (Optional)
This connector accommodates a Smart Card Reader that allows you to
conveniently make transactions such as financial, health care, telephony,
or traveling services through a Smart Card user interface software. When
using this connector, enable the field: “Onboard Smart Card Reader” in
section “4.4.2 I/O Device Configuration.”
P4T533-C
®
P4T533-C Smartcard
SMARTCON
NC
SCRFET#
NC NC
NC2 VCC GND
SCRUI SCRRES# NC
SCRCLK
1
NC
SCRREST
18. Infrared module connector (5-1 pin IR_CON)
This connector supports an optional wireless transmitting and receiving
infrared module. This module mounts to a small opening on system
chassis that support this feature. You must also configure the UART2
Use As parameter in BIOS to set UART2 for use with IR. See section
“4.4.2 I/O Device Configuration” for details.
Use the five pins as shown in Back View and connect a ribbon cable from
the module to the motherboard SIR connector according to the pin
definitions.
P4T533-C
®
P4T533-C Infrared Module Connector
Front View Back View
+5V IRTX
IRRX
(NC) GND
+5VSB IRRX IR
TX
CIRRX GND
IR_CON
1