Teka LP1 700 - Manual (Page 11)

R inse aid
T his product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on
the inside panel of the door .
L oading the rinse aid
R egardless of the type of detergent dispenser installed on
your appliance, you must proceed as indicated below when
loading the rinse aid.
To open the dispenser, turn the " 2" cap in an anti-clockwise
direction and then pour in the rinse aid, making sure not to
overfill. The amount of rinse aid used for each cycle can be
regulated by turning the " 3 " dose adjustor, located beneath
the " 2" cap, with a screwdriver. There are 6 different settings;
the normal dosage setting is 3.
H ow to fill rinse aid
1
Low
Full
When the low rinse aid indicator “ 1 ” is bright, it means the
rinse aid is low, you must load rinse aid .
10
2 3
en
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage ad-
juster should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjuster to a lower setting.