Teka GKST 95 N i4 Select - Manual (Page 32)

32
Instructions for assembly GB
Electrical connection
• The electrical connection must be carried out by a
qualified electrician who is authorised to carry out such
work!
• Statutory regulations and the connection specifications issued
by the local power supply company must be strictly observed.
• When connecting the appliance it must be ensured that there
is a device which makes it possible to disconnect it from the
mains at all poles with a contact opening width of at least
3 mm. Line-protecting switches, fuses or contactors are
suitable cut-out devices.
• When connecting and repairing the appliance disconnect it
from the electricity supply with one of these devices.
• The earth wire must be sufficiently long so that if the strain
relief fails, the live wires of the connecting cable are subjected
to tension before the earth wire.
• Any superfluous cable must be removed from the installation
area beneath the appliance.
• Make sure that the local mains voltage is the same as the
voltage on the rating label.
• Full protection against accidental contact must be ensured on
installation.
• Attention! Incorrect connection may result in the power
electronics unit being destroyed.
No mains cable present in the factory
• To connect the appliance, unscrew the switchbox cover on the
underside of the appliance to access the terminal block. After
connecting the appliance, replace the cover and secure the
connection cable with the strain relief clamp.
• The connection cable must be at least H05 RR-F.
• If the excess cable of this appliance is damaged, it has to be
replaced by the manufacturer, the Customer Service of the
manufacturer or by another qualified person to avoid danger.
Electrical connections
Mains cable available in the factory
• The induction hob has been fitted with a temperature-resistant
connection cable in the factory.
• Connection to the mains is carried out in accordance with the
circuit diagram, unless the connection cable is already fitted
with a plug.
• If damaged, the manufacturer or his customer service must
replace the connection cable installed with a special
connection cable.
Electrical connections
* Attention! Special power supply 230 - 240 V 3~ !
(for a supply voltage of 220 - 240 V/ 127 - 139 V !)
green-yellow green-yellow
bl
ue
whit
e
brown black
green-yellow green-yellow
bl
ue
whit
e
brown black
gr
een-yell
ow
gr
een-yell
ow
blue white br
own
black
gr
een-yell
ow
gr
een-yell
ow
blue white br
own
black