Teka GKST 95 N i4 Select - Manual (Page 26)

26
Operation GB
Automatic boost function
Parboiling takes place at power level 9 with the automatic boost function.
After a certain time the power level will switch down automatically to a lower
simmering setting (1 to 8).
When using the automatic boost function only the simmering setting with
which the food is to be cooked through needs to be selected since the
electronic unit switches down automatically.
The automatic boost function is suitable for dishes which are cold initially and
are then heated up at high power. These dishes do not need to be constantly
monitored when simmering (e.g. boiling meat for soups).
1. Switch a cooking zone on. The stand-by dot of the cooking zone selected
must light up. It may be necessary to press a cooking zone selection
button .
2. Select power setting 9. Pressing the plus button again will activate
the automatic boost function.
The power level setting will indicate A and 9 alternately.
In the case of induction, an A and will be shown if no pot has been
placed on the cooking zone.
3. Then immediately use the minus button to select a lower simmering
setting from 1 to 8.
A and the selected simmering setting will blink alternately.
4. The automatic boost function will operate as programmed. After a certain
time (see chart) the cooking process will be continued with the simmering
setting.
Please note
• While the automatic boost function is in operation, the plus button can be
used to raise the simmering power setting. Pressing the minus button
will switch the automatic boost function off.
• If, after activating the automatic boost function, the power level is left at
level 9 and no lower simmering setting is selected, the automatic boost
function will be switched off automatically after 10 seconds and the cooking
level will remain at 9.
• If a higher cooking setting or the power boost setting is activated, the
automatic boost function may switch off if the maximum power level is
exceeded (see power management).
Keeping warm function
With the function for keeping food warm you can use one of the cooking
zones to keep food warm. The respective cooking zone is operated at a low
power level.
1. Cookware is placed on a cooking zone and a power level (e.g. 3) is
selected.
2. Keep the minus button pressed to switch the power settings down
(... 3, 2, 1, ). The setting will stop at and the warming function will
have been activated.
3. Press the minus button once to de-activate the function (0).
This keeping warm function is available for 120 minutes; the hob will then be
switched off.
Power setting
Automatic boost function
Time (min:sec)
1
2
3
4
5
6
7
8
9 0:48
2:24
3:50
5:12
6:48
2:00
2:48
3:36
-
hold