Teka DPS 90 STAINLESS STEEL - Manual (Page 12)

Adjustment of the clock
• To remove the filters from their fittings, press
lightly on the locks and then pull them off.
• The metal filters can be cleaned by soaking
them in hot water with neutral detergent
until the fat dissolves and then rinsing them
under the tap or using special anti-grease
products. They can also be washed in a
dishwasher. In this case, it is advisable to
stack them vertically to avoid food residues
to stick to them.
• Cleaning in a dishwasher may damage the
metallic surface (blackening it), although
this will not affect its fat retention capacity.
• Once clean, leave them to dry off and then
fit them onto the kitchen hood.
• If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the
product instructions.
• If your kitchen hood is painted, use lukewarm
water and a neutral soap.
• Never use metallic scourers, nor abrasive or
corrosive products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
• Do not use vapour cleaners.
During cleaning and maintenance work, make
sure the safety instructions are complied with.
Cleaning the hood body
Cleaning and maintenance
1) Push the on/off’ button for 3 seconds.
2) Adjust the hour digits by pressing ‘+’ or ‘-’.
3) Push the on/off’ button again.
4) Adjust the minute digits by pressing ‘+’ or ‘-’.
5) After 3 seconds your settings are saved
automatically.
Cleaning the metal filters
Changing light bulbs
Proceed as follows:
• Unscrew the lamp cover.
• Change the broken / burnt out lamp.
• Screw the lamp cover back in.
GB