Staub Electronics EA-AMP-12D-70A EPISODE - 12 CHANNEL 70 WATTS DIGITAL AMPLIFIER WITH AUTO POWER User Manual

Page 5

pg.5

1. GLOBAL INPUT

Easily amplify outputs from any stereo source across any/all channels

2. LOOP OUT

Allows global inputs to be sent to other amplifiers

3. GAIN CONTROL

Allows independent gain for each pair of inputs

4. BRIDGED SWITCH

Easily couple two channels together for increased power

NOTE: 8-ohm minimum when using bridge mode

5. LINE INPUTS

Individual channel inputs for use with multi-channel preamps/ or dedicated sources

6. INPUT SWITCH

Choose between global inputs and individual inputs for each channel

7. SPEAKER OUTPUTS

8. MASTER POWER SWITCH

Disables power to the amplifier

7. POWER MODE SWITCH

Sets the amplifiers power mode:

On – Turns ON / OFF via front power button

12V – Turns on when +12V is received at Trigger input

AUDIO - Turns on when a minimal amount of audio signal is received at the audio

inputs and will go into standby after 18 minutes of no audio signal.

Note: The front panel power button is inoperative when the 12V Trigger or Audio Sense power

modes are selected.

10. 12V TRIGGER IN/OUT

Turns amplifier on when 12v dc is applied and power mode switch is set to 12v. This 12v

signal is regenerated to the 12v out for triggering additional amplifiers.

Note: the front panel power button is inoperative when the 12v trigger or audio sense power

modes are selected.

11. POWER CONNECTOR

12. FUSE LOCATION

EA-AMP-8D-70

11 12

This manual is related to the following products: