Staub Electronics EA-AMP-SUB-1D-500 EPISODE - DIGITAL SUBWOOFER AMP - Manual (Page 5)

5
4. CONTROL INPUT
a. Use this 1/8˝ Mono mini-jack to connect to most IR emitter output connections. The signal will be transferred
and flashed to the IR receiver internally behind the front panel. This will eliminate the need to add “stick-on”
emitters in most systems. NOTE: Due to variations in IR system types, not all are compatible with this control
jack. In some cases, an emitter will be needed to place over the front panel IR window.
5. SPEAKER OUTPUTS
a. Connect the speaker wires to the Binding Posts.
NOTE: Red is Positive and Black is Negative.
Bridged output, do not ground.
b. Use either Bare Speaker Wire or Banana Plugs to terminate the speaker wire.
6. AC POWER
a. Master Power ON/OFF power switch for the amplifier.
b. Input voltage setting selects the appropriate 115V or 230V setting.
c. IEC Power Cord
5 6