Audio Authority Series 1500 - Manual (Page 13)

12 Audio Authority ® Series 1500 Installer’s Reference Guide Audio Authority ® Series 1500 Installer’s Reference Guide 13
Using the 1550 Field Setup Tool
System Calibration and Setup
The Model 1550 is a liquid crystal display that shows the setup menus and settings for Series 1500 Intercom Systems.
The entire system can be calibrated from one Counter Station. Connect the 1550 Field Setup Display to the RJ45 jack
on the underside of any live Counter Station. (The jack is at an angle.) Upon connection, the 1550 will display “SERIES
1500 EQUIPMENT CALIBRATION PLATFORM”.
• Hold the SETUP key on the Counter Station for one second to enter Setup Mode. The 1550 displays the top level of
the menu shown on page 4.
• To navigate the menus, use the
VOLUME UP and VOLUME DOWN
keys to move the cursor.
• Use SETUP to enter a submenu or
confirm a selection, and PRIVACY
to go back.
• Any changes you make are
recorded as you exit each menu.
When you exit Setup Mode, you
must choose to either save all
changes and exit or exit without
saving.
• If you need to re-enter Setup Mode,
simply press SETUP for 1 second.
Power User Tips
• For faster menu navigation,
submenus may be selected by
touching the key that is lit RED
corresponding to the menu item
(see the numbered keys above).
For instance, to enter BLOWER
MOTOR DELAY, press 1 and then
1.
• To Exit Setup Mode from any menu,
hold SETUP for one second and
follow the prompts on the 1550.
• After adjusting a Lane Station or
Counter Station, use the CAMERA
UP or CAMERA DOWN keys to
select other stations for adjustment
without leaving the submenu.
VOLUME = Move menu
cursor up and down 1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
SETUP = Enter
or Confirm
PRIVACY = Go Back to
previous menu
CAMERA = Select next
or previous Station
(after selecting a single
Lane or Counter Station)
*Not available for 1 on 1
configurations
** Not available for 1509
Audio Hub
1:THIS TELLER
2:SINGLE TELLER
3:GROUP OF TELLERS
4:ALL TELLERS
5:CANCEL
1:BLOWER MOTOR DELAY
2:POWER SAVE DELAY **
3:SUPERVISOR TELLER *
4:LN MIRROR DISABLE **
5:TRAFFIC SENSOR TONE
6:BACKGRND THRESHOLD
1:SINGLE LANE
2:AUTO-SELECT 1 LANE
3:GROUP OF LANES
4:ALL LANES
5:CANCEL
1:INBOUND VOLUME LVL
2:OUTBOUND VOLUME LVL
3:OPEN LOOP GAIN
4:HANDSET MIC LVL
5:HANDSET SPKR LVL
6:RINGTONE OVERRIDE *
7:HALF DUPLEX ONLY
8:PROGRAM AUDIO ABATE *
9:RELAY OPERATION
1:KEY ASSIGNMENT **
1:CANCEL
2:FACTORY DEFAULTS
1:CANCEL
2:WRITE TO MEM. CARD
3:READ FROM MEM. CARD
4:FIRMWARE UPGRADE
1:CANCEL
2:EXIT AND SAVE
3:EXIT WITHOUT SAVING
1:SYSTEM PARAMETERS
5:MEMORY CARD *
2:LANE PARAMETERS
3:TELLER PARAMETERS *
4:SET DEFAULTS
6:EXIT
Setup Menu Map
Using the Keypad for Navigation