LevelOne HVE-6501T - Manual (Page 9)

 Receiver
1. DC5V: Connect to the supplied AC adapter and plug into an electrical outlet.
2. GIGA LAN: Connect directly to a Transmitter or to a GIGA(1000Mbps) Ethernet
Switch using CAT6 cable.
3. HDMI OUT: Connect to an HDMI display device with an HDMI M-M cable. Use
an HDMI --> DVI adapter if the display is DVI.
4. RS232: Connect to the RS232 port of the device you want to configure.
LEDs , button and Group ID setting
1. POWER LED Blinking: power on and the unit is booting up.
2. POWER LED On: power on and the unit is active.
3. LINK LED Off: LAN is not connected.
4. LINK LED On: LAN is connected.
5. DATA LED Blinking: The Receiver is connecting with Transmitter, or the HDMI
source is removed.
6. DATA LED On: All the connections are working.
7. PB 1 : Change Link/Unlink; Firmware Upgrade Mode and Reset to default*
using this button. Please to see the Button Descriptions.
8. PB 2 : change between Video Mode / Graphic Mode ; Anti-Dither ; Update
EDID* using this button. Please to see the Push Button Descriptions.
9. GROUP ID: The Receiver’s default GROUP ID is “0000”
 Transmitter & Receiver IP Address
The default setting is for “auto ip” mode and uses the 169.254.xxx.xxx private IP
domain range. The IP of target TX/RX board is resolved by its hostname using DNS
protocol. The RX’s HDMI GUI will display the RX’s IP address and the connected
TX’s IP address. You can see the RX’s HDMI GUI by connecting it with power
adapter and HDMI monitor only, without LAN cable.