LevelOne GVS-3800 User Manual
Page 24
18
available for Fast Ethernet. If the media is fiber, it is always 100Mbps and
the duplex is 100full/auto; if the media is TP, the Speed/Duplex is
comprised of the combination of speed mode, 10/100Mbps, and duplex
mode, full duplex and half duplex.
Flow Control:
There are two modes to choose in flow control, Enable and Disable. If
flow control is set “Enable”, both parties can send PAUSE frame to the
transmitting device(s)
while the receiving port is too busy to handle.
When it is set “Disable”, flow control will not exist in the port. It drops the
packet if too much to handle.
Default: Enable
Ingress Rate Limit and Egress Rate Limit:
There are some predefined rate settings. If user needs some special
usage, you could input the rate by yourself after “User Setting” has been
selected from pull down list. Because the rate limit is 64kbps as a
minimal step, the input rate limit, it should be divided exactly by 64. If the
rate value can not be divided exactly by 64, for example 65, the program
will be change the rate to 64 automatically.
Default: Not Limit